• borari@lemmy.dbzer0.com
          link
          fedilink
          English
          arrow-up
          0
          ·
          1 month ago

          Yeah, I’ve never heard of that before either. What I have heard of is either MOA or MIL reticles. In that context a Mil stands for milliradian, which is a representation of angle. That definitely doesn’t track with the post though.

          • Excrubulent@slrpnk.net
            link
            fedilink
            English
            arrow-up
            0
            ·
            1 month ago

            And it’s especially confusing for people who use sane measurement systems where “mil” is short for “millimetre”, because it’s just the start of the word. I think anyone that still insists on measuring things in thousandths of an inch should keep their own bespoke lingo too, and everyone else should steadfastly refuse to acknowledge “mil” in this context.

        • curiousPJ@lemmy.world
          link
          fedilink
          English
          arrow-up
          0
          ·
          edit-2
          1 month ago

          A couple old metrology equipment dated back from the 80s I still use calls them ‘mil’. It’s got dual dials for mil/mm. Gets me confused sometimes because the gauge can go down to couple millionths of an inch/couple 10s of nanometers.

          LVDT for those curious.

    • flying_gel@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      edit-2
      1 month ago

      A millimeter i.e a thousands of a meter.

      edit: I was wrong, confusingly enough it is a thousands of an inch

      • Aceticon@lemmy.world
        link
        fedilink
        English
        arrow-up
        0
        ·
        edit-2
        1 month ago

        In the design and manufacture of PCBs (aka circuit boards) a “mil” is a one thousandth of an inch, so it makes sense that’s what is being used in this context.

        Also the maths check out: 0.005 inches is equal to aprox 0.12mm, “just over 0.1mm”.

        • flying_gel@lemmy.world
          link
          fedilink
          English
          arrow-up
          0
          ·
          1 month ago

          I stand corrected, and I see I didn’t read the comment thoroughly enough either.

          Colloquially as a non-pcb maker I would use and hear the term “mill” as short form millimeter so I assumed it was that.

          so TIL :)

          • Aceticon@lemmy.world
            link
            fedilink
            English
            arrow-up
            0
            ·
            1 month ago

            Yeah, I found it wierd too when I started designing PCBs (as hobby) that “mill” actually stood for thousanth of an inch.

            Probably for historical reasons, there are tons of things in the older domains within electronics that are based on inches rather than metric units: for example the spacing between the legs of a microchip in the older chip package formats (so called DIP, the ones with legs that go into holes) is exactly 0.1"

            The sizes in more modern electronics isn’t usually based on inches anymore, but circuit boards are old tech (even if done with new materials) so there are still a number of measures in there which are based on inches.