• elucubra@sopuli.xyz
    link
    fedilink
    English
    arrow-up
    0
    ·
    15 days ago

    These things (and Seagate’s) have the usb interface soldered on, so if the drivd dies, forget about the data, no way to connect to another usb adapter to try to recover. Granted, it’s usually the drive that dies, but in these cases, you have a 100% rate of non recovery . Any other brand’s are standard drives. My favorite are toshiba.

    • tal@lemmy.today
      link
      fedilink
      English
      arrow-up
      0
      ·
      15 days ago

      Why would the USB electronics be particularly likely to fail relative to other electronics on the drive?

      • elucubra@sopuli.xyz
        link
        fedilink
        English
        arrow-up
        0
        ·
        14 days ago

        In my experience the drive fails more often than the adapter, but they do fail. Also, there is a good chance to recover data from a failed drive. With a soldered adaptor it’s basically impossible. The worst part is that the externals are often used for backups.

      • eskimofry@lemm.ee
        link
        fedilink
        English
        arrow-up
        0
        ·
        15 days ago

        Because that’s usually the cheapest part that manufacturers can get away with cheapening iut further.

      • Endorkend@kbin.social
        link
        fedilink
        arrow-up
        0
        ·
        15 days ago

        Because you flex and replug the interface often.

        The thing you use to plug your phone, tablet, drives and other things with is very often the failure point unless you break screens or get water in them.

        Normally you simply have a HDD drive with a SATA interface in there, so if the USB connector fails, you can still easily recover your data.

        With these things, you’re lucky if they even offer the possibility of repairing or recovering the drive.